Everything seemed to work well. for my application. Some of the pin holes were a little large for the header, however, they still work. Needed to modify one of the retaining clips on the header as well. Great product though, as it saved me countless hours of splicing!
I used this to construct an adapter harness to install a Megasquirt ECU into my 91 Miata. This is awesome because it lets you make your harness a very clean plug and play solution rather than splicing into the car's wiring harness. You can order the specified ECU plug that goes with this from mouser electronics. The board fits the connector perfectly and has two holes for wires routed to each pin on the plug. Also has holes that match up with the mounting holes in the connector - so you can secure it to the board with screws. Not much else to say about it, it works and is sturdy.
Top value for money kit. Could do with assembly instructions as the silkscreen is very difficult to read, but other than that if you are good at surface mount work then you will save yourself heaps over a ready made ecu.
Набор получил, собрать его не было возможности. Качество хорошее, с документацией небольшая путаница, обновления схем одних ревизий при отсутствии обновлений в других. Претензий нет, понимаю что процесс идёт и изменения будут.