What is this?
A generic enclosure for Speeduino V0.4 boards. if you are looking for a enclosure adapted for your speeduino V0.4 board, look no further.
What is included?
1x Extruded aluminum Hammond…
A generic enclosure for Speeduino V0.4 boards. if you are looking for a enclosure adapted for your speeduino V0.4 board, look no further.
What is included?
1x Extruded aluminum Hammond enclosure
1x Assembled front panel, with IDC40 cable and connector, siliconehose, power cables and panel mounted usb connector.
3x D-sub 9 pin connector for soldering, including black plastic backshell
1x 2 pin power connector
Speeduino board and Arduino is not included.
Assembly instructions
Procure one Speeduino V0.4 board with desired accessories and one Arduino Mega 2560.
Assemble and configure the Speeduino board with the desired jumpers.
Slide the Speeduino board into the box, in the fourth slot, counted from below..
Connect the supplied silicone hose to the manifold air pressure sensor.
Connect the power supply cables to the screw terminals.
Connect the USB connector to the arduino and the IDC 40 connector to the Speeduino board.
Slide on the lid of the box and fasten the back end plate with a PZ1 screwdriver.
By clicking Register, you confirm that you accept our Terms & Conditions
What is a Tindarian?
We recognize our top users by making them a Tindarian. Tindarians have access to secret & unreleased features.
How does one become a Tindarian?
We look for the most active & best members of the Tindie community, and invite them to join. There isn't a selection process or form to fill out. The only way to become a Tindarian is by being a nice & active member of the Tindie community!
/i/617032/products/2020-12-23T08%3A27%3A38.685Z-Listing2.jpg?1608683310)
