Tindie
Petit Studio
About
Engineer by day, electronic tinkerer by night.
Shipping Policies
Rates to United States of America
| Shipping Rate | First item | Additional items |
|---|---|---|
|
La Poste: Priority Mail, without tracking
|
$3.00 | $1.00 |
|
La Poste: Priority with tracking
|
$6.00 | $1.00 |
Reviews
Rd: Mads Vilms | Oct. 14, 2018
Everything as expected, amazing
For Pi Camera HDMI Cable Extension
A couple of days transport from France to Denmark. Product work exactly as promised. Just ordered 12 more.
Benjamin | Sept. 3, 2018
Everything perfect
For Pi Camera HDMI Cable Extension
Super nice product with a good finish. Hadn't time to test everything, but for now I'm happy with it.
Joel | Aug. 14, 2018
Great product
For Pi Camera HDMI Cable Extension
Thanks very much, really helped me out with my car rear view camera. It only worked with HDMI Highspeed with Ethernet, other HDMI Cables did not work.
Øyvind | July 18, 2018
Works great, but it depends on the cable
For Pi Camera HDMI Cable Extension
Tested with both a v1 and v2 camera, same results.
Worked fine with a short cable and a 3m cable.
Also worked fine with one 5m cable, but with another 5m cable, it didn't,
and there's no apparant difference between the two 5m cables.
DC resistances roughly the same: 4.5-5Ω (per wire) for the differential pairs and 12-13Ω
for the single wires. Didn't measure the impedances, so dunno if there's a difference there.
On the bad cable, the camera is deteced (no errors from raspivid), so the I²C bus must be
working, but there's no video signal, which raspivid complains about after a timeout.
The bad cable probably dampens the clock and/or data lines too much, but works fine when used on HDMI.
All cables tested needed the HDMI_Shroud-to-Camera_GND solder
joints, as the shield pins (HDMI pins 2,5,8,11) aren't connected.
Worked fine with a short cable and a 3m cable.
Also worked fine with one 5m cable, but with another 5m cable, it didn't,
and there's no apparant difference between the two 5m cables.
DC resistances roughly the same: 4.5-5Ω (per wire) for the differential pairs and 12-13Ω
for the single wires. Didn't measure the impedances, so dunno if there's a difference there.
On the bad cable, the camera is deteced (no errors from raspivid), so the I²C bus must be
working, but there's no video signal, which raspivid complains about after a timeout.
The bad cable probably dampens the clock and/or data lines too much, but works fine when used on HDMI.
All cables tested needed the HDMI_Shroud-to-Camera_GND solder
joints, as the shield pins (HDMI pins 2,5,8,11) aren't connected.
Julian | July 12, 2018
Good product, bad comunication
For Pi Camera HDMI Cable Extension
It's a good product, the documentation its very complete... but I did some questions to the seller and the answer was very slow or inexistent