What is Fire Fighting Robot?

The robot can be controlled from the detectable, as it is unreachable. In the robot, personalized sensors in temperature that detect fire are used. The robot that we will create as two versions. In the first version, the robot works autonomously according to the data from the sensors. The points that detect the fire can be extinguished with the help of water that can be passed on the robot. It interferes with propellers outside the water engine. The second version will be in the form of directing the robot from the bluetooth application to direct it to a certain point.

There are constant fires in life and the world in men, this process can prevent or intervene such fires as robots develop. Minimizing this loss.

Let's run our own steps through our robot then turning their weapons.

Click here for the product's installation guide

Set Content:

• 1 x Arduino UNO R3 Clone (w/USB Cable)
• 2 x L298N Dual Motor Driver Board with Voltage Regulator (Red PCB)
• 1 x 30 cm 40 Pin Detachable Male-Male M-M Jumper Cable-300 mm
• 1 x L9110 Drive Motor and Fan Module
• 1 x HC06 Bluetooth-Serial Module Board
• 3 x Fire Sensor Card (Flame Sensor)
• 1 x Mini Submersible Pump 6V 110 Liter/Hour
• 1 x 40 Pin Detachable Female-Male F-M Jumper Cable - 100mm
• 2 x 6 V 250 RPM Motor - Yellow Motor
• 2 x 50x11 mm Blue Color Plug-in Wheel Set
• 2 x Metal Ball Drunk Wheel - Green
• 1 x M3 Nut - 10 Pieces
• 1 x M3 15 mm YSB Star Cylindrical Head Metric Screw - 10 Pieces
• 4 x 50 mm M3 Metal Female-Male Spacer (Standoff-Spacer-Riser)
• Plexi Parts

The product does not contain batteries. It is recommended to use 1 x 7.4V 2S Lipo Battery 450 mAh 25C.