Dylan | March 16, 2025

Dylan | March 6, 2025

No instructions

For 2.13 inch EPD for Pwnagotchi with UPS-Lite

It doesn't explain anything. I know this isn't rocket science, but simple things like which pillar goes where and which end the button-cell battery goes toward the board would be helpful. A step-by-step guide would be even better.

As far as the actual product, the case should have a slot for the SD card.

Response from ACE design studio | March 8, 2025

Hello, thank you for your feedback. I will update the installation documents later so that others can follow clearly when using it.

In addition, regarding the issue of leaving an SD slot on the shell, since the SD card is relatively close to the inside after installation,
and the SD seat of the pi zero is not a pop-up type, it will be difficult to pull out the SD even if the shell leaves a slot. So I removed
the slot design in the final shell design.

if you encounter any problems during use, you can contact me at any time.

Mohammed | July 21, 2024

Matteo | March 27, 2024

Alejandro | July 25, 2023