Description

The IS4350-M1 is a module that integrates a Modbus TCP/IP Slave stack. It features an internal memory of 500 Holding Registers, accessible by both a microcontroller (via I2C) and a Modbus Master device (e.g., PLC, computer, etc.).

The goal of the IS4350 is to eliminate the engineering effort typically required to implement and validate Modbus TCP/IP communication. It offers a reliable, ready-to-use solution that helps reduce development time and speed up your time-to-market (TTM).

How it Works?

The chip provides two interfaces:

• An I2C interface for your microcontroller, FPGA, Arduino, Raspberry Pi, etc.
  ➜ This is where your system reads/writes Modbus data.

• A RMII to connect your preferred Ethnernet PHY transceiver.
  ➜ This is the fieldbus that connects to a PLC, computer, or machine.

The internal memory is composed of 504 registers: - 500 Holding Registers for user data. - 4 Configuration Registers for communication settings.

You can use the IS4350 in two main modes:

• As a Sensor → your microcontroller writes data to the chip via I2C.
• As an Actuator → your microcontroller reads data from the chip via I2C.
• As an Advanced Device → your microcontroller reads and writes data to and from the chip via I2C.

➡️ Just read/write the registers you need — no protocol stack required.

Default Chip Settings

Default Modbus Settings:

• Modbus Slave ID: 1

• IP: DHCP

Default I2C Settings:

• I2C Slave Address: 0x11 (fixed)

• I2C Speed: 100 kHz (when pin 7 is tied to GND)

Product Packaging

📦 Reels available for high-volume orders.

Questions?

💬 Contact us anytime for support.

This company and the products provided herein are developed independently and are not affiliated with, endorsed by, or associated with any official protocol or standardization entity. All trademarks, names, and references to specific protocols remain the property of their respective owners.