Important: Due to new outbreaks of COVID, post offices are suspending posting to some countries. Therefore, our store will run out of stock until January 31, 2022, which is the deadline for publishing the list of countries that will have normalized deliveries.

IMPORTANT: we ship all our items from Brazil via priority mail or express mail (EMS), and the customer is responsible for customs release and any import duties that may be due in the destination country.

Product Information

Highlights

• PCF8563 IC manufactured by NXP Semiconductors
• 256Kbit (32KB) CAT24C256 EEPROM manufactured by ON Semiconductor
• Three configurable bits for I2C address selection for the EEPROM chip, allowing simultaneous use of up to 8 chips on the same I2C bus (more details on the schematics)
• Battery holder for CR/BR 1216, 1220 or 1225 batteries
• Trimmer for crystal calibration
• Alarm feature
• Timer feature
• PCB pad to measure the RTC output clock
• CR1220 battery included
• Power supply input for 3.3V or 5V (configurable via solder jumpers)
• Access to the interrupt signal from the RTC chip (configurable via solder jumper)

Description

With the RTCMem Nanoshield you add a real time clock to your project, and 32KB more of non-volatile memory from an EEPROM chip embedded in the board. Interfacing with the RTC and the EEPROM memory is done through an I2C bus, using only 2 pins of your microcontroller. We provide open source Arduino libraries to access these resources.

The RTC chip on the board tracks day of month, day of week, month, year, hours, minutes and seconds. In the absence of a power supply, a lithium battery allows keeping track of the time for up to 10 years¹. Unlike the majority of the RTC boards in the market, where the clock can show a deviation of up to ±2 seconds per day (±20ppm), the RTCMem Nanoshield has a trimmer that is factory calibrated, such that the maximum deviation is ±0.5 seconds per day (±5ppm)¹.

The RTC chip also contains alarm configuration based on day of week, hours, minutes and seconds, possibly generating an event at a predetermined time. This event can cause an interrupt, that can be verified either via the INT pin or via an I2C command. Similar to the alarm feature, there is also a timer feature that can generate an event after a preconfigured period of time.

Arduino Libraries

• Nanoshield_RTC
• Nanoshield_EEPROM