Bask in the sheen of the WOPR64's skin in addition to its flashing lights!

This case is for the WOPR64 cartridge previously sold by The Dark Forest and Run Stop Re-Store. It helps protect your device and make it easier to handle while giving the exterior a metallic look based on the cinematic inspiration behind the name.

The right-angle extended cartridge port, reset button, and of course those glorious blinking lights remain accessible. The need for board standoffs is replaced by a foot attached to the case, and internal reinforcements prevent the WOPR64 board from flexing when inserting a cartridge.

Screws and threaded inserts provide for easy installation as well as ensuring that your device can be opened as needed for cleaning or other service.

Please note that this is a 3D-printed plastic enclosure (and necessary assembly hardware) only. The WOPR64 device is not included.

Assembly Instructions

The foot is stored inside the case during shipping.

• Use the included allen wrench to open the case by removing the two screws on the bottom.
• Use the two included shorter (8mm) screws to attach the foot to the bottom half of the case, under the cartridge slot location. (Be careful not to overtighten.)
• Insert the red button activator into the hole in the top half of the case.
• Seat your WOPR64 board into the bottom half of the case.
• Place the top half of the case, ensuring that it fully seat over the alignment tabs.
• Reinstall the two case screws through the bottom of the case.

Enjoy!