Tindie
patshead.com
About
You can find my blog at http://blog.patshead.com.
Reviews
Tom | May 14, 2019
Great design, works very well.
This is a very clever design which, when expanded, enables you to work on a complicated project in a space-efficient physically stable platform. I have a raspberry pi, Arduino mega, esp8266, span tilt servo mechanism and a ton of breadboarded components all connected in a tidy compact workspace that I can carry easily in one hand. Yes it is held together by rubber bands but the design locks everything down and it seems very sturdy even “fully loaded” with gear. Very happy with my purchases - I bought two. Extremely versatile and useful.
Logan | Dec. 22, 2017
Pretty cool, easy to break, too tall for thicker fans
For Cooling Fan Duct For Silverstone DS380B Case
My drives run ~10C cooler with the ducts in place, although my MB now runs ~3C hotter since the air passing over it is now passing over the drives first. I'd consider this a perfectly fine trade off.
I have the "Nidec Servo Gentle Typhoon D1225C12B5AP 120mm 1850 rpm Silent Case Fan" and I found I had to manually trim about 1cm off the top of the duct for the drive bay to still fit in the case with the duct in place. You could probably make the ducts that much shorter by default to accommodate more fan types and still get good results with thinner fans and the small gap.
One of the screw holes on each duct broke while I was attaching them to the fans. This was probably because I had to remove the ducts to trim them and that added extra stress to the bracket. I'd suggest future printings to add more thickness to those areas.
I have the "Nidec Servo Gentle Typhoon D1225C12B5AP 120mm 1850 rpm Silent Case Fan" and I found I had to manually trim about 1cm off the top of the duct for the drive bay to still fit in the case with the duct in place. You could probably make the ducts that much shorter by default to accommodate more fan types and still get good results with thinner fans and the small gap.
One of the screw holes on each duct broke while I was attaching them to the fans. This was probably because I had to remove the ducts to trim them and that added extra stress to the bracket. I'd suggest future printings to add more thickness to those areas.
Mark | July 20, 2017
brittle
For Cooling Fan Duct For Silverstone DS380B Case
The product serves intended function of increasing airflow, however the screw holes are not perfectly aligned and is brittle, easy to break if screwing in too tightly
