Impressive project board with a number of features, both to run as standalone controller/driver or integrate with another controller (MQTT / API). Documentation could be improved, though overall very pleased with the build and functionality.
Hi! I well received the board, and i have to say, it is great.
I understand that the stock firmware is based on the configurable ptvo.info firmware. Could you let us know what are the parameters set in the firmware ? Pin number associated with each output, inputs linked to output ? Are the push button connected to the same terminal as the contacts available on terminals ?
Is it possible to set up a relay to make contact only for a limited time ? (to emulate a push button).
Response from ALab Technology | Sept. 18, 2020
Hi, the firmware emulates ptvo
INPUTS: P0.0, P0.1, P0.2, P0.3 (all linked to outputs, push buttons connected to the same terminals) LED_STATUS: P1.7 RELAYS: P1.6, P1.5, P1.4, P1.3 BUZZER: P1.2
Do you want to configure via a cluster parameter or flash a new firmware? I can make a new firmware where it will be possible to dynamically change the operating mode of the inputs. but you need to flash a new firmware by CC Debugger.
Just switched it on and it joined the zigbee2mqtt-Network.
Edit: Documentation was updated, so I upgraded the rating by one star. But it would also be nice to see more documentation: - How to configure the buttons? (Did not use them yet) - Which firmwares are available? Open Source?
The product itself works great. I use it for shutters and garage door.
Response from ALab Technology | Aug. 11, 2020
Sebastian, thanks for the feedback! Added instructions to the product description. To reset, press button 1 for more than 20 seconds.