This is new v4.00 SCLD stands for Solar Charger Led DriverDesigned by Burgduino, Ships from Greece
What is it? SCLD6 is a lithium battery charger module with a wide voltage input capability designed to charge a 1SxP lithium battery pack from either small solar panels or DC input and drive Leds d...Read More…
SCLD6 is a lithium battery charger module with a wide voltage input capability designed to charge a 1SxP lithium battery pack from either small solar panels or DC input and drive Leds during the night
There is a need for outdoors lighting solutions but most are either too expensive or too weak. This is a compact solution with the only thing limiting its applications being your imagination!
SCLD has a wide voltage input which can be anything from 5V and all the way up to 45V (max), allowing to operate with virtually any DC source within the range like old laptop charger, router wall adapter, old atx psu, solar panels etc.
SCLD can charge a single series battery pack (1 or more in parallel if needed). It will charge with max 1A and the battery is fully protected against short circuit, over voltage & over discharge
JOULE THIEF OUTPUT
SCLD is designed to operate with LED arrays with forward voltage above 4.5V. It will illuminate 12V LED strips and even 12V flood lights but the result will be good for illumination, not for brightness (LEDs will not operate at full capacity, the higher the power rating of the LEDs, the dimmer they will be).
There is a great window for experimentation with various LEDs and it does surprise with some! It works absolutely great with 2 x 0.75W power LEDs or with short lengths of low power LED strips (it is tested to illuminate a whole 5m reel though, works nice to illuminate a corridor for example)
SCLD's practical applications are only limited by your imagination!
It can function as a night light, garden light, replacing the photoresistor with a PIR sensor it can be motion activated etc. It is particularly well suited to replaced aging or failing NiCd/NiMH garden lights or to create your own!
This is the latest revision of the original SCLD with several changes both in terms of layout and parts used. It is now using a Consonanse CN3153 charger IC, has only two through hole parts (two electrolytic caps + the photoresistor which the user has to solder).
You can house it in a small waterproof box with a pack of batteries and power it from DC or Solar source (12V/3W solar panel for a single 18650 battery is more than enough) then use it as the power source to light smaller pieces of 12V led strips spread around a building or a yard etc. If powered by a DC source it will always be charged in case of a power failure.
You will receive a fully assembled and tested SCLD v4 module and a photoresistor which you can either solder on the PCB or wire to an enclosure of your choice to suit your final application.
PCB dimensions 49x30mm (12.7mm max height)
|Shipping Rate||First item||Additional items|
Shipping via Airmail first class with ELTA (Greek Post) Orders of 5 or more will be shipped via Registered Airmail
We recognize our top users by making them a Tindarian. Tindarians have access to secret & unreleased features.
We look for the most active & best members of the Tindie community, and invite them to join. There isn't a selection process or form to fill out. The only way to become a Tindarian is by being a nice & active member of the Tindie community!
Enjoy creating, create enjoyment!