What is it?

It is a device which performs a deauth attack. You select the clients you want to disconnect from their network and start the attack. As long as the attack is running, the selected devices are unable to connect to their network. Other attacks also have been implemented, such as beacon or probe request flooding.

Why did you make it?

I designed this development board for spacehuhn's great project: esp8266_deauther

It has already been authorized by spacehuhn.

How it works

The 802.11 Wi-Fi protocol contains a so called deauthentication frame. It is used to disconnect clients safely from a wireless network.

Because these management packets are unencrypted, you just need the mac address of the Wi-Fi router and of the client device which you want to disconnect from the network. You don’t need to be in the network or know the password, it’s enough to be in its range.

Disclaimer

Use it only for testing purposes on your own devices! I don't take any responsibility for what you do with this program.

Please check the legal regulations in your country before using it. What it does, how it works and how to protect against it is described on the GitHub page (link above).

What makes it special?

• Wifi deauther programm preflashed
• 18650 Battery charging system integrated
• Over charge protection
• Over discharge protection
• Pocket size 10x3 cm
• Indicate LED control available (GPIO16)
• Operate like NodeMCU
• smt connector for deep sleep mode
• 6 GPIO break out(ADC,D3,D4,D8,D9,D10)
• 3V/5V output
• Micro USB input(5~12V)
• 1 Switch controlls the power.
• Indication LED (red = chargin, green = fully charged)
• Can charge and work at the same time

**Be careful + and -. If you put the wrong direction of battery the charging chip will be destroyed.

This product does not include 18650 battery.**