Swiss design - small is beautifull
Bicolor leds shows the excitation on the motors, but the motors will run only if the switch is on. This is great while debugging the software.
The MsMot size is only 14x55mm. You have the choice to solder straight or bent connectors. With bent connectors, you hardly see the MsMot, and you have all the space for your breadboard. Use female connectors with long pins if you need to add a traditional shield that will use the free pins..
The MsMot ic connected to the 4 usual Arduino pins 4,5,6,7 to control the motor, with PWM on pin 5 and 6. Motor drivers are the Si9986, 3 to 6V, 1A max, 300 mA with only 0.2V loss (compare with the L293!). For the power, MsMot takes the Gnd from the Gnd pin next to pin13. The last pin is the Aref signal nobody use. That pin can be connected to +5V without any arm. Add a wire, and do it below your arduino board, it is very convenient to have a +5V on that side of the board. This is one of the advantage of the Tindie Diduino2.
The two PWM channels of pins 5 and 6 can provide variable speed in both directions , you just need to know the trick, explained on http://www.didel.com/robots/MotorControl.pdf
Last, but not the least, you can experiment on a breadboard – nice to understand the basics.
|Shipping Rate||First item||Additional items|
Swiss Post: Standard Ground Rate (No Tracking Code)
We recognize our top users by making them a Tindarian. Tindarians have access to secret & unreleased features.
We look for the most active & best members of the Tindie community, and invite them to join. There isn't a selection process or form to fill out. The only way to become a Tindarian is by being a nice & active member of the Tindie community!
Many years in microcontroller educational field.
We love robots, clean solutions and efficient power usage.
We develop and need debugging help, see what we did develop for ourselves you can get