A serial controllable synthesizer that will output any frequency between 33MHz to 4.4GHz. Arduino Pro Mini + ADF4351Designed by ZachTek, Ships from Sweden
What is it? It's a frequency generator that you control using serial commands. The synth has a built-in pre-programmed Arduino Pro Mini that runs a commands parser so you can set any frequency simp...Read More…
It's a frequency generator that you control using serial commands.
The synth has a built-in pre-programmed Arduino Pro Mini that runs a commands parser so you can set any frequency simply by sending is over the serial port.
It can be run on voltages from 3,3V to 5V and takes about 140mA of current.
There are two complimentary 50 ohms outputs that give out 0dBm. The output is pretty flat over the entire frequency range. (See picture)
It has a stability of 2.5ppm (parts per million) or better when using the built-in TCXO 10MHz reference. If you need more precision or stability there is an input for your own frequency reference.
The frequency steps are 1MHz at 4GHz and about 150kHz at 40MHz. Future firmware may improve on this and might include I2C support as well.
To set the frequency to 150MHz simply send the command SETFREQ 150000000 on the serial port. There is also support for sweeping between a start and stop frequency, for incrementing or decrementing the frequency, turning off or on voltage regulators etc. See Screenshots for more info on serial commands.
The Synth uses an IDC10 connector for all signals and power but a standard FTDI header is also available.
To solve my frequency needs in Radio receivers, transmitters, Lab equipment etc.
It is designed with good care for electric parameters like frequency stability, phase noise etc while still being easy to use so it can be used by novice as well as the more advanced RF engineers. If you know how to use a serial port you can use this device!
|Shipping Rate||First item||Additional items|
Posten AB: Standard Ground Rate
Basic tracking. Insured to full value.
James | Dec. 20, 2017
We recognize our top users by making them a Tindarian. Tindarians have access to secret & unreleased features.
We look for the most active & best members of the Tindie community, and invite them to join. There isn't a selection process or form to fill out. The only way to become a Tindarian is by being a nice & active member of the Tindie community!
I'm a electronics technician with hardware design as my speciality and software as a side line.
My interests and expertise are wide ranging but RF and Radio technology excites me the most.
I started doing electronic design in my own company when I was fresh out of school but after a few years I
became an IT Manager and have been working in the Computer industry for 30+ years at large International Software companies.
So now I'm finally going back to my roots by designing hardware for myself and for the public.
I take on custom jobs if I can fit them in.
My products are aimed to people that want to have an electronics piece to fit in to their project without to much hassle.
I try therefore to have my products pre-programmed and ready to use.
They are for the most part open in hardware and software so you can change them and tweak them.
I hope you will find something of interest among my products and that they will serve you well.
Harry @ ZachTek