Join 3d printer filament with this controllerDesigned by JasonKits, Ships from Malta
What is it? The filament Fuser/joiner allows you to melt both ends of the filament in question at the right temperature and join them to produce one run of coloured filament. Why did you make it? ...Read More…
The filament Fuser/joiner allows you to melt both ends of the filament in question at the right temperature and join them to produce one run of coloured filament.
In my previous versions I always saw the need to improve my design and mostly safety features. So I re designed it from the ground up to include lots of new goodies
This version has a setup menu with options such as sensor type, temperature display mode such as celsius or fahrenheit, PID mode is selectable and LCD brightness.. it has safety timeouts and sensor detection, if sensor is unplugged or goes open circuit the controller shuts down. Other features include auto adaptive tuning and hot end shutdown when knob is at zero.
Setup Menu Includes these features
Restore defaults 11: Save settings
All Values are stored in eeprom and loaded when controller boots up .
A Full user manual is Included with the controller explaining how to enter the setup menu and use the controller safely.
Can be connected to any common heater 4 Ohm to 12 Ohm - and aluminium block ..
Controller has a 16x2 lcd which displays the setpoint and hot end temperatures .
Temperature is controlled by P.I.D
The controller can switch between Basic and Auto tune mode / Normal / Aggressive mode
Set point control pot range from 0 to 300 degrees temperature is controlled via PID . Temperature can be shown as degrees C or degrees F
Set point range 0 - 10 : Switches Heater off . Set point range 11 - 300 : Switches Heater on .
Sensor Check when booting and while operating - with no sensor connected the controller shows an error message no Sensor !
In line - Poly Fuse .75 Amp on electronics
Calibration of sensor if enabled
Startup delay for sensor calibration Warmup
Supplied ready built and tested - with 5 amp PSU 110-220V A.C
|Shipping Rate||First item||Additional items|
Maltapost: Standard Ground Rate
We recognize our top users by making them a Tindarian. Tindarians have access to secret & unreleased features.
We look for the most active & best members of the Tindie community, and invite them to join. There isn't a selection process or form to fill out. The only way to become a Tindarian is by being a nice & active member of the Tindie community!
Jason Kits established in 2005, Providing a variety of electronics kits, varying from solar and wind generating controller kits to 3D printing add-on kits and various parts . Promoting kits for free energy generation and enhancing the 3D printing experience JasonKits is committed to provide you with quality and state of the art products . Since then Jason Kits kept its pace and kept evolving adding ever more products and expanding further in various other areas , AVR based kits, various other categories of electronic kits and Ham radio related Kits.