Got the package yesterday, shipping is a little bit longer than expected which is totally acceptable for the economy postage. The boards themselves are nice looking & great quality. Will definitely order again.
Product is as advertised, delivered fast in a nice and small bubble enveloppe.
However I'm a noob and I just wasted one unit after trying to fix the short I made on the SMA connector, because I didn't notice how close the connectors are between GND and ANT on the PCB, didn't use any flux and put too much solder, lesson learned :D
Fortunately I bought 4 of those and had better luck on my second attempt :-)
Response from Low Power Design Lab | Sept. 27, 2018
Thank you so much :-) Sorry that your one unit got wasted, If you are using solder "wire" then I would suggest using solder "paste" instead because with paste it is super easy to slide SMA over the breakout board and with this your one hand is free to hold SMA in place. Good Luck :-)